BENSHAW RSi H2 Series - Page 343

Communications
331
890053-00-02
10.4.5.1 Analog Value Object Instance
Instance ID
Object Name
Description
Setting Range
Units
R/W
AV1
CommTimeoutSet
Command timeout setting
0.1–120.0
Secs
R/W
AV2
AccelTimeSet
Accelerate time setting
0.0–600.0
Secs
R/W
AV3
DecelTimeSet
Decelerate time setting
0.0–600.0
Secs
R/W
AV4
CommandFreqSet
Command frequency
setting**
0.00–DRV-20
Hz
R/W
AV5
PIDReferenceSet
PID reference setting
0–100.0
%
R/W
AV6
PIDFeedbackSet
PID feedback setting
0–100.0
%
R/W
10.4.5.2 Multi-state Value Object Instance
Instance ID
Object Name
Description
Setting Range
Units
R/W
MSV1
LostCommand
Command lost
operation setting
0: None
1: FreeRun
2: Dec
3: HoldInput
4: HoldOutput
MSG
R/W
5: LostPreset
When PowerOn Resume (COM-96) is set to ‘yes’, value is saved even if the power of the
inverter is disconnected. When PowerOn Resume (COM-96) is set to ‘no’, value is not
saved if the power of the inverter is disconnected.
A value higher than the maximum frequency (DRV-20) cannot be used. The maximum
frequency can be set by using the keypad. This value can be used when Freq Ref Src (DRV-
07) is set to ‘Int 485’.
AV2, AV3 and AV4 are used to provide acceleration/deceleration rate and frequency
reference commands. These can be written in AUTO mode only.