BENSHAW RSi H2 Series - Page 387

Technical Specifications
375
890053-00-02
Control Circuit Terminal Screw Specification
Terminal
Terminal Screw Size
Screw Torque
in-lbs. (Nm)
P1–P7 / CM, VR, V1, I2 / TI / S+, S-, SG /
A1/B1/C1, A2-C2, A3-C3, A4-C4, A5-C5 /
AO1, AO2 / 24V, Q1, EG
M3
1.95 - 2.2
(0.22 ~ 0.25)
Apply rated torques to the terminal screws. Loose screws may cause short
circuits and malfunctions. Tightening the screw too much may damage the
terminals and cause short circuits and malfunctions. Use copper wires only
with 600 V, 90°C rating for the power terminal wiring, and 300 V, 75°C rating
for the control terminal wiring.