Performing Basic Operations
3.2.2.3 Mode Buttons and LED Status
Used to enter the HAND operating mode and start the inverter.
Used to enter the OFF mode (standby mode) or to reset faults.
Used to enter the AUTO operating mode or to start and stop inverter operation in
AUTO mode.
Turns on green (steady) during HAND mode operation.
Turns on red (steady) while the inverter is in OFF mode (standby) and flashes
when a fault occurs. When the OFF LED is flashing, a fault is present. Press the OFF button.
The LED turns on red (steady) when the fault is reset.
Turns on green (flashing) when the inverter is in AUTO (Ready) mode but is not
operating. Turns on (steady) when the inverter operates (runs) in Auto mode.
To Next Page
Loading...
