BENSHAW RSi H2 Series - Page 8

viii
Table of Contents
890053-00-02
5.6.25 Damper Open .......................................................................... 176
5.6.26 Pump Clean ............................................................................. 176
5.6.27 Sleep Wake Chg ...................................................................... 176
5.6.28 PID Step Ref L, PID Step Ref M, PID Step Ref H ................. 177
5.6.29 Digital Input Terminal Control ................................................... 177
5.7 Output Group (OUT) ............................................................................ 179
5.7.1 OUT-01, OUT-07 Analog Outputs ........................................... 179
5.7.2 OUT-31 Digital Outputs ........................................................... 183
5.7.3 OUT-41 Digital Output Status ................................................. 187
5.7.4 OUT-30 Fault Output using Relay or Q1 Terminals ............... 187
5.7.5 OUT-50 Multi-function Output Terminal Delay Time Settings 189
5.7.6 OUT-67 Relay Output On/Off Control ..................................... 190
5.8 Protection Group (PRT) ....................................................................... 191
5.8.1 PRT-01 Backspin Timer .......................................................... 191
5.8.2 PRT-05 Phase Loss Protection ............................................... 192
5.8.3 PRT-08 Automatic Reset and Restart ..................................... 192
5.8.4 PRT-11 Keypad Loss and Speed Reference Loss ................ 195
5.8.5 PRT-17 Overload Trip and Early Warning .............................. 197
5.8.6 PRT-23 Under Load Fault and Warning ................................. 199
5.8.7 PRT-31 No Motor Trip ............................................................. 200
5.8.8 PRT-34 Motor Over Heat Sensor ............................................ 201
5.8.9 PRT-40 Electronic Thermal Prevention (ETH) ....................... 203
5.8.10 PRT-44 Fire Mode ................................................................... 205
5.8.11 PRT-50 Stall Prevention and Flux Braking ............................. 207
5.8.12 PRT-60 Pipe Break Detection .................................................. 211
5.8.13 PRT-66 Dynamic Braking (DB) Resistor Configuration ......... 212
5.8.14 PRT-70 Level Detection .......................................................... 214
5.8.15 PRT-79 Fan Fault Detection.................................................... 217
5.8.16 PRT-80 Option Card Trip ......................................................... 217
5.8.17 PRT-81 Low Voltage Fault ...................................................... 218
5.8.18 PRT-82 Selecting Low Voltage 2 Fault During Operation ...... 218
5.8.19 PRT-90 Low Battery Voltage Warning .................................... 218
5.8.20 PRT-91 Broken Belt ................................................................. 219
6 PID Control Group (PID) .............................................................................. 220
6.1 PID Parameter List .............................................................................. 220
6.2 PID Basic Operation ............................................................................ 224
6.3 Application Group 1 (AP1) ................................................................... 233
6.3.1 AP1 Parameter List ................................................................. 233