Brother LX27NT - Attachment of Needle-Presser Module; Attachment of Stopper Plate

2 - 29
Upper shaft, Needle bar and Presser foot unit Basic of Assembly
Basic Basic
1 Attachment of Needle-presser module
1. Set the shaft 1 of the needle-presser module 2 to the 2 positioning
grooves of the arm bed, and secure them with the 2 screws 1.
2. Tighten the screw 2 to the back side of the arm bed.
→Refer to 3 - 42 of the Assembly.
1
2
2
1 111
2
Taptite, Cup S
M4X16
Cup screw
M3X20
2 Attachment of Stopper plate
1. Attach the stopper plate 1 to the back side of the arm bed with the screw
1.
1
1
1
Screw, Bind
M4X8