Procedure for Setting a Shared Folder as a Save
Location
1647-022
Before conguring the machine for scanning to shared folders, check the setup ow shown below.
Make sure that the machine and the computer are correctly connected.
Connecting to a Wireless LAN(P. 17)
Connecting to a Wired LAN(P. 16)
Make sure that you have the following information:
● The IP address of the machine. Viewing Network Settings(P. 37)
● The name of the computer where the shared folder is located. Checking the
Computer Name(P. 732)
● Path to and the name of the shared folder (If access restrictions are set to the
folder, the user name and password information is also needed).
● For instructions on how to create a new shared folder, see "Send Setting Guide"
(included with the provided DVD-ROM).
Make sure that the computer meets the system requirements for the Send
Function Setting Tool.
● System requirements for the Send Function Setting Tool
System
Environment(P. 714)
● Also make sure that <Use HTTP> and <Use Remote UI> are set to <On>.
Disabling HTTP Communication(P. 414)
Disabling Remote UI(P. 415)
Set the machine conguration. Setting a Shared Folder as a Save
Location(P. 94)
Setting Up
93
To Next Page
Loading...
