Canon imageCLASS MF735Cdw - Procedure for Setting to Send E-Mail;Send and Receive I-Fax

Procedure for Setting to Send E-Mail/Send and Receive
I-Fax
1647-01Y
Before conguring the machine for scanning to e-mail, check the setup ow shown below.
Make sure that the machine and the computer are correctly connected.
Connecting to a Wireless LAN(P. 17)
Connecting to a Wired LAN(P. 16)
Make sure that you have the following information:
● The IP address of the machine. Viewing Network Settings(P. 37)
● An e-mail address to be registered as a destination.
● Information about the e-mail server, including the SMTP server name, port
numbers, whether authentication is required, and the user name and password
for authentication.
● For more information about the e-mail server settings, contact your Internet
service provider or Network Administrator.
Make sure that the computer meets the system requirements for the Send
Function Setting Tool (sending e-mail).
● System requirements for the Send Function Setting Tool
System
Environment(P. 714)
● Also make sure that <Use HTTP> and <Use Remote UI> are set to <On>.
Disabling HTTP Communication(P. 414)
Disabling Remote UI(P. 415)
Set the machine conguration.
● Conguring Basic E-Mail Settings Conguring Basic E-Mail Settings(P. 86)
● Conguring I-Fax Receiving Settings Conguring E-Mail/I-Fax
Communication Settings(P. 89)
● Conguring Detailed E-Mail/I-Fax Communication Settings (Authentication,
Encryption, etc.) Conguring E-Mail/I-Fax Communication Settings(P. 89)
Setting Up
85