#099
An operation that caused a job to be canceled has been performed.
● When you cancel a job, this error code is displayed, but this is not abnormal. Print, send, or receive
documents again as necessary.
#401
A scanned original could not be stored to a USB memory device due to insucient memory space.
● Delete unnecessary data to free space in the USB memory device, or connect a different USB memory
device.
Insert a USB Memory Device(P. 106)
#406
A scanned document could not be stored to a USB memory device due to an error.
● Remove the USB memory device, and connect it again.
Insert a USB Memory Device(P. 106)
● Reduce the number of originals to scan.
#408
Read failed because the USB memory device was removed while data was being read from it.
● Check that the USB memory device has not been removed and then read the data again.
Insert a USB Memory Device(P. 106)
Printing from a USB Memory Device (Memory Media Print)(P. 270)
The connected USB memory device is using an unsupported format.
● Check that the USB memory device is using a format supported by this machine.
Insert a USB Memory Device(P. 106)
#701
Authentication failed because an incorrect Department ID or PIN was entered when the Department ID
Management was activated.
● Enter the correct Department ID and PIN.
Continuing operating without entering a Department ID was attempted even though unknown-ID jobs
(functions that permit operations without a Department ID and PIN) were disabled in the Department ID
Management.
● Enable unknown-ID jobs in System Manager Mode in Remote UI.
Troubleshooting
660
To Next Page
Loading...
