6.
CHECK THE HYDRAULIC PRESSURE SENSOR
• Replace the hydraulic pressure sensor with a known good sensor.
• Start the vehicle and monitor the value of 9HYDRAULIC PRESSURE9 with the X-431 scan tool.
Is the check result normal?
Yes
>> Go to the next step.
No
>> Replace the hydraulic pressure sensor.
7.
CHECK DTC
• With the X-431 scan tool, read AMT control module DTCs.
• Refer to 9DTC Confirmation Procedure9.
Is DTC P0932 still present?
Yes
>> Replace the AMT control module (See AMT Control Module Removal & Installation in Section 08
Transaxle).
No
>>
The system is now operating properly.
Reassemble the vehicle and road test to verify the customers complaint is repaired.
DIAGNOSIS & TESTING
08
08–95
Chery Automobile Co., Ltd.
To Next Page
Loading...
Need help?
General
