Front Axle Shaft
Removal & Installation
NOTE :
The following special tools are required to perform the repair procedure:
• CH-10002 - Ball Joint Separator
1. Raise and support the vehicle.
2. Remove the wheel mounting nuts and the tire and wheel assembly.
(Tighten: Wheel mounting nuts to 110 N·m)
3. Remove the front wheel speed sensor retaining
bolt (1) and set the wheel speed sensor aside.
(Tighten: Wheel speed sensor bolt to 15 ± 2 N·m)
4. Remove the axle shaft hub nut from the front
knuckle.
(Tighten: Axle shaft hub nut to 135 N·m)
5. Remove the front brake caliper (See Front Brake Caliper Removal & Installation in Section 12 Brake).
6. Remove the nut (1) attaching the outer tie rod end
to the steering knuckle.
(Tighten: Outer tie rod end nut to 40 ± 5 N·m)
7. Using special tool CH-10002, separate the tie rod
from the steering knuckle.
ON-VEHICLE SERVICE
PZSM100011
BESM100001
LTSM110034
09–6
Chery Automobile Co., Ltd.
To Next Page
Loading...
