Cisco Catalyst 3750-X Command Reference

2-464
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
permit (IPv6 access-list configuration)
Syntax Description protocol Name or number of an Internet protocol. It can be one of the keywords
ahp, esp, icmp, ipv6, pcp, sctp, tcp, or udp, or an integer in the range
from 0 to 255 representing an IPv6 protocol number.
source-ipv6-prefix/prefix-
length
The source IPv6 network or class of networks for which to set permit
conditions.
This argument must be in the form documented in RFC 2373 where the
address is specified in hexadecimal using 16-bit values between colons.
any An abbreviation for the IPv6 prefix ::/0.
host source-ipv6-address The source IPv6 host address for which to set permit conditions.
This source-ipv6-address argument must be in the form documented in
RFC 2373 where the address is specified in hexadecimal using 16-bit
values between colons.
operator [port-number] (Optional) Specify an operator that compares the source or destination
ports of the specified protocol. Operators are lt (less than), gt (greater
than), eq (equal), neq (not equal), and range (inclusive range).
If the operator is positioned after the source-ipv6-prefix/prefix-length
argument, it must match the source port.
If the operator is positioned after the destination-ipv6-prefix/prefix-length
argument, it must match the destination port.
The range operator requires two port numbers. All other operators require
one port number.
The optional port-number argument is a decimal number or the name of a
TCP or a UDP port. A port number is a number from 0 to 65535. TCP port
names can be used only when filtering TCP. UDP port names can be used
only when filtering UDP.
destination-ipv6-prefix/
prefix-length
The destination IPv6 network or class of networks for which to set permit
conditions.
This argument must be in the form documented in RFC 2373 where the
address is specified in hexadecimal using 16-bit values between colons.
host
destination-ipv6-address
The destination IPv6 host address for which to set permit conditions.
This destination-ipv6-address argument must be in the form documented
in RFC 2373 where the address is specified in hexadecimal using 16-bit
values between colons.
dscp value (Optional) Match a differentiated services codepoint value against the
traffic class value in the Traffic Class field of each IPv6 packet header. The
acceptable range is from 0 to 63.
fragments (Optional) Match noninitial fragmented packets where the fragment
extension header contains a nonzero fragment offset. The fragments
keyword is an option only if the protocol is ipv6 and the operator
[port-number] arguments are not specified.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing