2-545
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
sdm prefer
Table 2-23 lists the approximate number of each resource that is supported in each of the IPv4-only
templates for a switch. The values in the template are based on 8 routed interfaces and 1024 VLANs and
represent the approximate hardware boundaries set when a template is selected. If a section of a
hardware resource is full, all processing overflow is sent to the CPU, seriously impacting switch
performance.
Note On switches running the LAN base feature set, none of the routing values shown for the templates are
valid.
Table 2-24 lists the approximate number of each resource supported in each of the dual IPv4-and IPv6
templates.
Note On switches running the LAN base feature set, routing values shown in all templates are not valid.
Table 2-23 Approximate Number of Feature Resources Allowed by IPv4 Templates
Resource Access Default Routing VLAN
Unicast MAC addresses 4 K 6 K 3 K 12 K
Internet Group Management Protocol
(IGMP) groups and multicast routes
1 K 1 K1 K1 K
Unicast routes 6 K 8 K 11 K 0
• Directly connected hosts 4 K 6 K 3 K 0
• Indirect routes 2 K 2 K 8 K 0
Policy-based routing access control entries
(ACEs)
0.5 K 0 0.5 K 0
Quality of service (QoS) classification ACEs 0.5 K 0.5 K 0.5 K 0.5 K
Security ACEs 2 K 1 K1 K1 K
VLANs 1 K 1 K 1 K 1 K
Table 2-24 Approximate Feature Resources Allowed by Dual IPv4-IPv6 Templates
Resource
Dual IPv4-and IPv6 Templates
Indirect IPv4 and
IPv6 Routing Default VLAN Routing
Unicast MAC addresses 2 K 8 K 1.5 K 2 K
IPv4 IGMP groups and multicast routes 1 K 1 K (IGMP)
0 (multicast)
1 K 1 K
Total IPv4 unicast routes: 3 K 0 2.7 K 4 K
• Directly connected IPv4 hosts 2 K 0 1.5 K 2 K
• Indirect IPv4 routes 1 K 0 1.2 K 2 K
IPv4 policy-based routing ACEs 0 0 0.25 K 0.125 K
IPv4 or MAC QoS ACEs (total) 0.5 K 0.5 K 0.5 K 0.5 K
IPv4 or MAC security ACEs (total) 1 K 1 K 0.5 K 0.625 K