2-813
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show switch
This example shows how to display detailed stack-ring activity information for a switch stack:
Switch> show switch stack-ring activity detail
Switch Asic Rx Queue-1 Rx Queue-2 Rx Queue-3 Rx Queue-4 Total
-------------------------------------------------------------------------
1 0 2021864 1228937 281510 0 3532311
1 1 52 0 72678 0 72730
---------------------------
Switch 1 Total: 3605041
-------------------------------------------------------------------------
2 0 2020901 90833 101680 0 2213414
2 1 52 0 0 0 52
---------------------------
Switch 2 Total: 2213466
-------------------------------------------------------------------------
Total frames sent to stack ring : 5818507
Note: these counts do not include frames sent to the ring
by certain output features, such as output SPAN and output
ACLs.
Link OK This shows if the link is stable.
The link partner is a stack port on a neighbor
switch.
• No—The link partner receives invalid
protocol messages from the port.
• Yes—The link partner receives valid protocol
messages from the port.
Link Active This shows if the stack port is in the same state as
its link partner.
• No—The port cannot send traffic to the link
partner.
• Yes—The port can send traffic to the link
partner.
Sync OK
• No—The link partner does not send valid
protocol messages to the stack port.
• Yes—The link partner sends valid protocol
messages to the port.
# Changes to LinkOK This shows the relative stability of the link.
If a large number of changes occur in a short
period of time, link flapping can occur.
In Loopback
• No— At least one stack port on the member
has an attached stack cable.
• Yes—None of the stack ports on the member
has an attached stack cable.
Table 2-49 show switch stack-ports summary Command Output (continued)
Field Description