2-825
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
show vlan
Primary Secondary Type Ports
------ --------- ----------------- ------------------------------------------
Primary Secondary Type Ports
------- --------- ----------------- ------------------------------------------
20 25 isolated Gi1/0/1,Gi3/0/1
20 30 community Gi1/0/1, Gi3/0/1
20 35 community Gi1/0/1, Gi3/0/1
<output truncated>
This is an example of output from the show vlan dot1q tag native command:
Switch> show vlan dot1q tag native
dot1q native vlan tagging is disabled
Table 2-52 show vlan Command Output Fields
Field Description
VLAN VLAN number.
Name Name, if configured, of the VLAN.
Status Status of the VLAN (active or suspend).
Ports Ports that belong to the VLAN.
Type Media type of the VLAN.
SAID Security association ID value for the VLAN.
MTU Maximum transmission unit size for the VLAN.
Parent Parent VLAN, if one exists.
RingNo Ring number for the VLAN, if applicable.
BrdgNo Bridge number for the VLAN, if applicable.
Stp Spanning Tree Protocol type used on the VLAN.
BrdgMode Bridging mode for this VLAN—possible values are source-route bridging
(SRB) and source-route transparent (SRT); the default is SRB.
Trans1 Translation bridge 1.
Trans2 Translation bridge 2.
Remote SPAN VLANs Identifies any RSPAN VLANs that have been configured.
Primary/Secondary/
Type/Ports
Includes any private VLANs that have been configured, including the
primary VLAN ID, the secondary VLAN ID, the type of secondary VLAN
(community or isolated), and the ports that belong to it.