EasyManuals Logo

Cisco Catalyst 3750-X Command Reference

Cisco Catalyst 3750-X
1244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #985 background imageLoading...
Page #985 background image
2-953
Catalyst 3750-X and 3560-X Switch Command Reference
OL-29704-01
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
switchport trunk
remove removes the defined list of VLANs from those currently set instead of replacing the list.
Valid IDs are from 1 to 1005; extended-range VLAN IDs are valid in some cases.
Note You can remove extended-range VLANs from the allowed VLAN list, but you cannot
remove them from the pruning-eligible list.
Separate nonconsecutive VLAN IDs with a comma; use a hyphen to designate a range of IDs.
except lists the VLANs that should be calculated by inverting the defined list of VLANs. (VLANs
are added except the ones specified.) Valid IDs are from 1 to 1005. Separate nonconsecutive VLAN
IDs with a comma; use a hyphen to designate a range of IDs.
vlan-atom is either a single VLAN number from 1 to 4094 or a continuous range of VLANs
described by two VLAN numbers, the lesser one first, separated by a hyphen.
Defaults The default encapsulation is negotiate.
VLAN 1 is the default native VLAN ID on the port.
The default for all VLAN lists is to include all VLANs.
Command Modes Interface configuration
Command History
Usage Guidelines Encapsulation:
The switchport trunk encapsulation command is supported only for platforms and interface
hardware that can support both ISL and IEEE 802.1Q formats.
You cannot configure one end of the trunk as an IEEE 802.1Q trunk and the other end as an ISL or
nontrunk port. However, you can configure one port as an ISL trunk and a different port on the same
switch as an IEEE 802.1Q trunk.
If you enter the negotiate keywords and DTP negotiation does not resolve the encapsulation format,
ISL is the selected format. The no form of the command resets the trunk encapsulation format to the
default.
The no form of the encapsulation command resets the encapsulation format to the default.
Native VLANs:
All untagged traffic received on an IEEE 802.1Q trunk port is forwarded with the native VLAN
configured for the port.
If a packet has a VLAN ID that is the same as the sending-port native VLAN ID, the packet is sent
without a tag; otherwise, the switch sends the packet with a tag.
The no form of the native vlan command resets the native mode VLAN to the appropriate default
VLAN for the device.
Release Modification
12.2(53)SE2 This command was introduced.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals