- 123 -
CT-P29x series
(1) Printer status (When n = 1 is specified)
Bit Status Hex. Decimal
0 Fixed 00H 0
1 Fixed 02H 2
2 Fixed 00H 0
Online status 00H 0
3
Offline status 08H 8
4 Fixed 10H 16
Not waiting online recovery 00H 0
5
Waiting online recovery 20H 32
FEED switch is not pressed 00H 0
6
FEED switch is pressed 40H 64
7 Fixed 00H 0
(2) Status caused by an offline condition (When n = 2 is specified)
Bit Status Hex. Decimal
0 Fixed 00H 0
1 Fixed 02H 2
Head-down 00H 0
2
Head-up 04H 4
Not in paper feed state triggered by FEED switch
00H 0
3
In paper feed state triggered by FEED switch
08H 8
4 Fixed 10H 16
Printing is not stopped because of “paper out”
state
00H 0
5
Printing is stopped because of “paper out” state 20H 32
Error not occurred 00H 0
6
Error occurred 40H 64
7 Fixed 00H 0
Bit 5: Printing is stopped if the Paper-end detector detects a “paper out”
state, or if the printer is out of paper when the Paper Near-end Sensor
is enabled by ESC c 4. At this time, bit 5 = 1.
(3) Status caused by an error (when n = 3 is specified)
Bit Status Hex. Decimal
0 Fixed 00H 0
1 Fixed 02H 2
No Mechanism error occurred.
00H 0
2
A Mechanism error occurred.
04H 4
Auto cutter error not occurred 00H 0
3
Auto cutter error occurred 08H 8
4 Fixed 10H 16
Unrecoverable error not occurred 00H 0
5
Unrecoverable error occurred 20H 32
Auto recovery error not occurred 00H 0
6
Auto recovery error occurred 40H 64
7 Fixed 00H 0
Bit 2: In case of MSW3-8=ON, it is generated by cover-open.
Bit 3: If this error occurred because of a paper jam, for example, remove the
cause of the error, and then DLE ENQ n (1≤n≤2) can be used to
recover from the error. However, it is not possible to recover from any
error due to a circuit problem (e.g., broken wire).
Bit 6: If a head overheat error is detected, the printing is stopped until the
head temperature falls. At this time, bit 6 = 1.
To Next Page
Loading...
