- 190 -
GS p n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Changing paper type
[Code] <1D>H <70>H <n>
[Range] 0≤n≤255
n=0 specify receipt paper
n=1 specify label paper
n=2 specify blackmarkpaper
[Outline] [The specification which is commontothemodel]
•Switches paper.
•n= 0:Switches to receipt paper (mode).
Ignores this command when receipt mode is set.
•n =1:Switches to label paper mode.
Measures paper length or sets first position of paper in accordance with the MSW setting.
Ignores this command when label paper mode is set.
•n= 2:Switches to BM paper mode.
Measures paper length or sets first position of paper in accordance with the MSW setting.
Ignores this command when BM paper mode is set.
[Caution] [The specification which is commontothemodel]
•Processed after buffering.
•This command is not initialized by the initialization command.
•This command is initialized by power OFF and paper type set by MSW is valid from the next
power ON.
•When BM paper/Label paper mode is changed to receipt mode
Change the paper to receipt paper after sending this command (n=0) with BM paper/label
paper set. If the paper is changed to receipt paper beforehand, sensing the first position
is not available when closing the cover, resulting in BM/label detection error.
•When receipt mode is changed to label mode
Send this command (n=1) after changing the paper from receipt paper to label paper. If
this command is sent beforehand, label detection error is caused.
To Next Page
Loading...
