Citizen CT-S280 - Msw6

- 422 -
4.2.6 MSW6
●MSW6-1: Mode to use with the driver
[Outline] Selects the valid/invalidof mode touse with thedriver
OFF(0) ON(1)
Mode touse with thedriver Invalid Valid
ON(1) OPERATION: FAULTsignal is notoutput inthe error conditiontoparallelport..
ASB is validatpoweron. (Same behavior asGS ancommandandn=15)
OFF (0) OPERATION:FAULTsignal isoutput in theerror conditionto parallel port..
ASB is ｉｎvalid atpower on.(Same behavior asGS an command andn =0)
●MSW6-2: Character space mode
[Outline] Selects the valid/invalidof mode tohave right space for eachcharacter
OFF(0) ON(1)
Character space mode Invalid Valid
ON(1) OPERATION: Default ofrightspace ofeachcharacteris“0”.
Same behavior asESC SP ncommand andparameter n=0.
OFF (0) OPERATION:Default of right space of each characteris “1”.
The right vertical dot column in character composition matrix is repeated in the additional right space. In this
mode,number ofcolumnsfor font BandC isdecreased by1 -4.
●MSW6-3： USB Power Save
[Outline] Select the valid/invalid of USB Power save mode.モードに自動的に入るか、入らないかを設定する。
OFF(0) ON(1)
USB Power Save
Invalid Valid
When printer is connected to the host through USB, if PC power is turned off or USB cable is
disconnected, printer enters special power save mode. This is USB Power save mode.
ON(1) OPERATION: Eventhecondition issatisfied, printer does notenter USBPowersave mode.
OFF (0) OPERATION:Whenthe condition issatisfied, printerenterstheUSB Power save mode.