Citizen CT-S280 - ESC SP N

- 60 -
ESC SP n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310 II
[Function] Setting the right spacing ofthe character
[Code] <1B>H<20>H<n>
[Range] 0≤n≤255
[Outline] [The specification which is commontothemodel]
•Sets theright spacing ofcharacter to [n×basiccalculation pitch] inches.
[Caution] [The specification which is commontothemodel]
•Ifthehorizontal magnification ofcharacteris2 ormore, theright spacing increases withthe
magnification.
•Does not affect Kanji.
•The right spacing canbesetseparatelyfor the STANDARD andPAGE MODES.
•ThebasiccalculationpitchissetbyGSP.Oncedefined,therightspacingisnotchangedifthebasiccalculation
pitch ischanged byGS P.
•Fractionsresultingfromcalculation are corrected withthe minimum pitch of themechanism, andthe
remainderisomitted.
•InSTANDARD MODE, thiscommanduses the horizontal basic calculation pitch(x).
•InPAGE MODE, thebasic calculation pitchusedbythiscommanddependson thestart point:
(1) If thestart point specifiedby ESCT is top leftor bottom right, thecommanduses thehorizontal basic
calculationpitch(x).
(2) If thestart point specifiedby ESCT is top right or bottom left, thecommanduses thevertical basic
calculationpitch(y).
•The maximum right spacing iscapableofapproximately 31.906 mm(255/203 inches). Asetting greater
than thismaximumis trimmedto themaximum.
[Default] n=0
[The specification which depend on the model]
CT-S801/CT-S851/CT-S601/CT-S651
MSW6-2 ON: n=0
MSW6-2 OFF: n=1
[See Also] GS P
[Sample Program] [PrintResults]
LPRINTCHR$(&H1B);" "; CHR$(0);
LPRINT"AAAAA";CHR$(&HA);
LPRINTCHR$(&H1B);" "; CHR$(1);
LPRINT"AAAAA";CHR$(&HA);
LPRINTCHR$(&H1B);" "; CHR$(12);
LPRINT"AAAAA";CHR$(&HA);
ＡＡＡＡＡ
Ａ Ａ Ａ Ａ Ａ
Ａ Ａ Ａ Ａ Ａ
0
-
dot space
1
-
dot space
12-dotsspace