Citizen CT-S280 - Black Mark Control Commands; Gs Ff

- 181 -
2.2.15 Black Mark Control Commands
GS FF
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Printing andejecting Black markpaper/ label paper
[Code] <1D>H<0C>H
[Outline] [The specification which is commontothemodel]
•Thiscommandprints thedata intheprinterbuffer andejects Black mark paper/ labelpaper.
[The specification which depend on the model]
•When auto cutter disabled is selected
CT-S2000/CT-S4000/CT-S801/CT-S851/CT-S601/CT-S651
(1)Feeds the printed black mark/label paper to the position to be cut by the manual cutter
or to be peeled off.
(2)Keeps waiting till cutting is made and FEED SW is pressed while blinking LED.
(3)If FEED SW is pressed, setting the first position of BM paper/label paper is carried out.
• The printer is in the BUSY state till the processing of (3) is executed. If, however,
FEED SW is not pressed in 3 seconds, the same operation as that with FEED SW is
executed.
CT-S281
(1)Feeds the printed black mark/label paper to manual cut position or manual peel off
position.
(2)Keeps waiting till cutting is made and FEED SW is pressed while blinking LED
•MSW3-7(CBM-270compatible mode) =ON: Keep waitingfor FEED SW being pressed.
•MSW3-7(CBM-270 compatible mode) = OFF: If FEED SW is not pressed in 3 seconds
(default), the same operation as that with FEED SW is executed.
Thetime to wait for manual cut can be changed by<GS (E >command.
(3) WhenFEED SW ispressed, feed the paper todetect next blackmark/topoflabel
•Printer isin BUSYstate until (3)transaction isdone.
•WhenMSW4-5=OFF(Black mark), printerfeed thepaper backward by about 5mm.
•WhenMSW4-5=ON(Labelpaper)ifthedistancebetweenblackmarkorlabellengthislessthan30mm,
next orsecond nextblackmark/labelwill beejected and thenfeed paper until detecting the black mark
ortop oflabel.
•When auto cutter enabled is selected
CT-S2000/CT-S4000/CT-S801/CT-S851/CT-S601/CT-S651/CT-S281
(1)The printed black mark/label paper is fed to the auto cutter position and full cutting is
carried out.
(2)Setting the first position of next BM paper/label paper is carried out.
[Caution] [The specification which is commontothemodel]
•Valid onlyifBlack markpaper/ labelpaper isselected.
[See Also] FF, GS <