Citizen CT-S280 - Esc L

- 334 -
ESC L
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Selecting PAGE MODE
[Code] <1B>H<4C>H
[Outline] [The specification which is commontothemodel]
•Switchesfrom STANDARD MODE to PAGE MODE.
[Caution] [The specification which is commontothemodel]
•Thiscommandis onlyeffectiveif it entered atthebeginningofa line.
•Thiscommandis noteffective if itis enteredwhenin PAGE MODE.
•STANDARDMODEisrestored whenprintingspecified by FF isfinished orwhenESC Sisissued.
•Thecharactermapping start position willbe thepoint specifiedbyESCTin theprintareaspecifiedby ESCW.
•The commands listed below,whichhave separate settings for PAGE MODE andSTANDARD MODE, are
changedtothe settingsforPAGE MODE use.
(1) Spacing setting: ESC SP,FSS
(2) Linefeed width setting: ESC 2, ESC3
•The following commandsare valid onlyin PAGE MODE.
(1) ESCV Specifying/canceling90°-right-turned characters.
(2) ESCa Aligning thecharacters.
(3) ESC{ Specifying/canceling theinvertedcharacters.
(4) GS L Setting the leftmargin.
(5) GS W Setting the print area width.
•The following commandsare disabled in PAGE MODE.
(1) GS (A Executestest printing.
(2) FS p Prints NVmemorybitimage.
(3) FS q Defines NVmemorybitimage.
(4) GS v0 Prints rasterbitimage.
•ESC @restores STANDARD MODE.
[See Also] Appendix 5.1.4“Example of using PAGEMODE”
FF, CAN, ESC FF, ESC S, ESC T, ESC W, GS W, GS \