- 165 -
GS g 0 m nL nH
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Initializing maintenance counter
[Code] <1D>H<67>H<30>H<m><nL><nH>
[Range] m=0
20≤(nL+nH×256)≤70(nL=20, 21,50, 70, nH=0)
[Outline] [The specification which is commontothemodel]
•Set the value of resettable maintenance counter specified to 0.
•nL, nH are used to set the maintenance counter number to (nL+nH×256).
Counter Number
Hex. Decimal
Counter [Unit]
14H 20 Paper-feed line [line]
15H 21 Headpowering count [times]
32H 50 Auto-cutter drivecount [times]
46H 70 Product operationtime [hours]
[Caution] [The specification which is commontothemodel]
• This command, if used frequently, may destroy NV memory, thus write command to NV memory shall be
used less than [10 times/day] asa guideline.
• Along with processing this command, during data-writing to NV memory, printer BUSY may occur. During
the printer BUSY, to stop receive processing, this printer prohibits the data sending (including real-time
command) from host.
To Next Page
Loading...
