- 178 -
FS S n1 n2
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Setting Kanjispace amount
[Code] <1C>H<53>H<n1><n2>
[Range] 0≤n1≤255
0≤n2≤255
[Outline] [The specification which is commontothemodel]
•Sets bothright andleft space amount of Kanji in units of dot.
•Sets leftspace amount by [n1×(Basic calculation pitch)] .
•Sets right space amount by [n2×(Basic calculation pitch)] .
[Caution] [The specification which is commontothemodel]
•The right andleftspace amount indouble-width mode aretwice the setting.
•Settingindependent line feed amount ispossible inSTANDARD MODEand PAGE MODE.
•Basic calculation pitch is setby GS P.Evenifbasic calculation pitch is changed byGS Pafter setting space
amount,there isno change inthe amount oflinefeed.
Whenfractionalnumber is caused bythecalculation,itiscorrectedbytheminimum pitchof mechanismand
the rest is discarded.
•InSTANDARD MODE, basic calculation pitch (x) inhorizontal directionisused.
•InPAGE MODE, thefollowingoperation occursdepending on thestartpoint.
(1) Whenthe start point is set at“upper left” or “lower right” byESCT, basic calculation pitch(y) ofvertical
direction (paperfeed direction) is used.
(2)Whenthestartpointissetat“upperright”or“lowerleft”byESCT,basiccalculationpitch(x)ofhorizontal
direction (at right angle topaper feed direction)is used.
•Themaximumrightspacingiscapableofapproximately31.906mm (255/203inches).A settinggreaterthan
this maximum istrimmed tothe maximum.
[Default] n1=0,n2=0
To Next Page
Loading...
