Citizen CT-S280 - Msw3

- 412 -
4.2.3 MSW3
●MSW3-1: Auto-cutter return
[Outline] Selects thereturn method from cutterlockerror.
OFF(0) ON(1)
Resum CttrErr Valid Invalid
ON(1) OPERATION: Return bycommand.
Afterremovingerror cause, return withcommand<DLEENQ n>.
OFF (0) OPERATION:Return withFEED switch.
Afterremovingerror cause, return bylong pressingFEED SW (1secor longer).
●MSW3-2: Clearing Cover Open Error
[Outline] Selects themethod ofclearingCover Openerror.
OFF(0) ON(1)
ResumOpen Err Close Command
OperationatON(1):
When theprinterdetectsthat coverisclosed andtheprinter receivesacommand <DLE+ENQ+n>, the
erroris cleared.
OperationatOFF(0):
When theprinterdetectsthat the cover isclosed, it automatically clearstheerror.
*With BD2-2220, Cover Open corresponds to Head Up (Platen Open).
●MSW3-2： Paper end signal output at detecting paper near end
(Only for CT-S801/CT-S851/CT-S601/CT-S651)
[Outline] SelectstheValid/InvalidofPE signalatdetecting PNE
OFF(0) ON(1)
PE output atPNE Valid Invalid
OPERATIONatON (1):
When paper near end is detected, printer output the PE signal from parallel interface. This is same behavior
ofESCｃ 3n command and n=15.
OPERATIONatOFF (0):
When paper near endis detected, printer does not output the PE signal from parallel interface. This is same
behaviorof ESCc 3nand n=12.