- 349 -
GS P x y
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Specifying the basic calculation pitch
[Code] <1D>H<50>H<x><y>
[Range] 0≤x≤255, 0≤y≤255
[Outline] [The specification which is commontothemodel]
•Thiscommandsets thehorizontal basic calculation pitchto approx.25.4/xmm (1/xinches),andthevertical
basiccalculation pitchtoapprox.25.4/y mm (1/y inches).
•Ifx =0,thehorizontalbasic calculation pitch is reverted tothe defaultvalue.
•Ify =0,thevertical basic calculation pitchisreverted tothe defaultvalue.
[Caution] [The specification which is commontothemodel]
•The horizontal directionisdefined as the direction perpendiculartothe paper feed, andthe
vertical directionis definedasthe paper feed direction.
•InSTANDARDMODE,thefollowingparametersareusedregardlessofthecharacterorientation(e.g.inverted
or90°-right-turned).
(1) Commandsusingx: ESCSP,ESC $, ESC
\
,FS S,GS L, GS W
(2) Commandsusingy: ESC3, ESCJ
•InPAGE MODE, theparameters useddependonthe character orientation,asfollows:
(1) If thestart point specifiedby ESCT is the topleft or bottom right (Thecharacters aremappedin the
direction perpendiculartothepaperfeed):
•Commands usingx:ESCSP,ESC$, ESCW, ESC
\
,FS S
•Commands usingy: ESC3,ESCJ,ESC W, GS $,GS
\
(2) If thestart point specifiedby ESCT is the topright orbottom left (The characters are mappedin the
paperfeed direction):
•Commands usingx:ESC3, ESCJ,ESC W, GS$, GS
\
•Commands usingy: ESCSP,ESC $,ESCW,ESC
\
,FS S
•Thiscommanddoes not affect anyother values that are alreadyset.
•Ifcalculations made in combination withanother commandgenerate fractions, the fractions arecorrected
with theminimumpitch of themechanism, andtheremainder isomitted.
[Default] x=203,y=360
[See Also] Appendix 5.1“Explanation onPAGE MODE”
ESC SP,ESC $, ESC3, ESCJ,ESC W, ESC
\
,GS $, GSL, GS W
To Next Page
Loading...
