Citizen CT-S280 - Ct-S300

- 383 -
4.1.3 CT-S300
No. Setting OFF ON
MSW1-1 Power ON Info ● Valid Not send
MSW1-2 Buffer Size ● 4K bytes 45 bytes
MSW1-3 Busy Condition ● Full/Err Full
MSW1-4 Receive Error ● Print ? No Print
MSW1-5 CR mode ● Ignored LF
MSW1-6 Reserved ● Fixed -
MSW1-7 DSR Signal ● Invalid Valid
MSW1-8 Init Signal ● Invalid Valid
MSW2-1 Reserved - ● Fixed
MSW2-2 Auto Cutter Invalid ● Valid
MSW2-3 Spool Print ● Invalid Valid
MSW2-4 Full Col Print LineFeed ● WaitData
MSW2-5 Resume aft PE ● Next Top
MSW2-6 Paper width ● 80mm 58mm
MSW2-7 Reserved ● Fixed -
MSW2-8 PNE Sensor ● Valid Invalid
MSW3-1 Resum Cttr Err ● Valid Invalid
MSW3-2 Resum Open Err ● close command
MSW3-3 Parallel 31 Pin ● Valid Invalid
MSW3-4 Paper Select ● Thermal Black MK
MSW3-5 Column Number ● 48/32 col 42/30 col
MSW3-6 Reserved ● Fixed -
MSW3-7 CBM1000 Mode ● Invalid Valid
MSW3-8 Resum Open Err ● Close command
MSW4-1 BM Measure ● Invalid Valid
MSW4-2 BM Sensor ● surface Back
MSW4-3 Reserved ● Fixed -
MSW4-4 Reserved ● Fixed -
MSW4-5 Reserved ● Fixed -
MSW4-6 Reserved ● Fixed -
MSW4-7 Reserved ● Fixed -
MSW4-8 Partial only Invalid ● Valid
●: Factory setting
<<Differenceof MSW by the model>>
MSW3-4 andMSW4-2 aredifferentbythemodel asfollows.
Model Standardmodel
Blackmark model
(Sensor at front sideof
paper)
Blackmark model
(Sensor at back sideof
paper)
MSW3-4 OFF Thermal paper ON Black mark ON Black mark
MSW4-2 OFF Front surface OFF Frontsurface ON Back side