- 57 -
ESC J n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Printing andfeeding paper inminimum pitch
[Code] <1B>H<4A>H<n>
[Range] 0≤n≤255
[Outline] [The specification which is commontothemodel]
•Prints the data held in theprint buffer andfeeds paper by [n×basic calculation pitch] inches.
[Caution] [The specification which is commontothemodel]
•After this command isexecuted, the beginning of thelineis taken asthe startpositionforthenext print.
•The line feed width canbe set separatelyfor the STANDARD andPAGE MODES.
•Thiscommanddoes not affect the linefeed width defined byESC2 or ESC 3.
•The basiccalculation pitchisset by GS P.
•Fractionsresultingfromcalculation are corrected withthe minimum pitch of themechanism, andthe
remainderisomitted.
•InSTANDARD MODE, thiscommanduses the vertical (paper feed direction) basic calculation pitch(y).
•InPAGE MODE, thiscommandacts differentlydepending on thestart point:
(1) If thestart point specifiedby ESCT is top leftor bottom right, thecommanduses thevertical (Paper
feed direction) basic calculation pitch(y).
(2) If thestart point specifiedby ESCT is top right or bottom left, thecommanduses thehorizontal
(Perpendicular tothe paper feed direction) basic calculation pitch(x).
•The maximum settable linefeed width is 1016mm (40inches).A settinggreater thanthismaximum is
trimmed tothemaximum.
[Default] Theinitial value is notdefined.
To Next Page
Loading...
