Citizen CT-S280 - GS V M; GS V M N

- 140 -
GS V m --- (1)
GS V m n --- (2)
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Cuttingthe paper
[Code] (1)<1D>H<56>H<m>
(2)<1D>H<56>H<m><n>
[Range] (1)0≤m≤1,48≤m≤49
(2)m=65,66
0≤n≤255
[Outline] [The specification which is commontothemodel]
•Performs thespecified paper cutting.
m Function
0,48
Full cut
1,49
Partial cut(Leaving abridge area uncut)
65
Paper feedby“cut position+ {n×basiccalculation pitch}” andfull cut
66
Paper feedby“cut position+ {n×basiccalculation pitch}” andpartialcut
[Caution] [The specification which is commontothemodel]
•InSTANDARD MODE, thiscommandonlyworks whenitisenteredat thebeginningofa line.
•Controltomake thelength of cutpaper less than10 mmis notexecuted.
For (1):
•Executes cutting ofpaper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n ≠0, the paper is fed by “n x basic calculation
pitch” inches past thecut position,and then cut.
•The basiccalculation pitchisset by GS P.The paperfeed amount is calculated with thevertical basic
calculationpitch(y). Afraction resultingfrom the calculation iscorrected withthe minimum pitch of the
mechanism, andthe remainder isomitted.
MSW4-8=ON:This commandworks aspartialcut command only.
[The specification which depend on the model]
CT-P290/292
•Thiscommanddoesnotfunction.
CT-S300/CT-S310/CT-S2000/CT-S4000/CT-S801/CT-S851
CT-S601/CT-S651/PMU series
•With label- or BM-supported model, this command does not function at the setting of BM
paper/label paper setting.
PMU2300III
•When presenter function is enabled, cut methodis automatically set for fullcut.