Citizen CT-S280 - Ct-S281

- 381 -
4.1.2 CT-S281
No. Setting OFF ON
MSW1-1 Power ON Info ● Valid Not send
MSW1-2 Buffer Size ● 4K bytes 45 bytes
MSW1-3 Busy Condition ● Full/Err Full
MSW1-4 Receive Error ● Print “?” No Print
MSW1-5 CR mode ● Ignored LF
MSW1-6 Reserved ● Fixed -
MSW1-7 DSR Signal ● Invalid Valid
MSW1-8 Reserved ● Fixed -
MSW2-1 Reserved - ● Fixed
MSW2-2 Auto Cutter Invalid ● Valid
MSW2-3 Spool Print ● Invalid Valid
MSW2-4 Full Col Print LineFeed ● WaitData
MSW2-5 Resume aft PE ● Next Top
MSW2-6 Reserved - ● Fixed
MSW2-7 Reserved ● Fixed -
MSW2-8 PNE Sensor Valid ● Invalid
MSW3-1 Resum Cttr Err ● Valid Invalid
MSW3-2 Reserved ● Fixed -
MSW3-3 Reserved - ● Fixed
MSW3-4 Reserved ● Fixed -
MSW3-5 Reserved ● Fixed -
MSW3-6 Reserved ● Fixed -
MSW3-7 CBM270 Mode Invalid ● Valid
MSW3-8 Resum Open Err ● Close Command
MSW4-1 P. Length Set ● Auto Measure Command
MSW4-2 Power on TOF ● Invalid Valid
MSW4-3 FEED&CUT at TOF Invalid ● Valid
MSW4-4 Paper Select ● Thermal Roll BM.P / Lbl.P
MSW4-5 Position detect ● Black Mark Label
MSW4-6 C.Close Action ● Find TOF Auto Measure
MSW4-7 AutoPaperSelect
● Invalid Valid
MSW4-8 Partial only Invalid ● Valid
MSW5-1 Reserved ● Fixed -
MSW5-2 Reserved ● Fixed -
MSW5-3 USB Mode Virtual COM ● Printer Class
MSW5-4 Reserved ● Fixed -
MSW5-5 Reserved ● Fixed -
MSW5-6
Reserved ● Fixed -
MSW5-7
ClearPNE LED
● Auto Paper set
MSW5-8 Reserved ● Fixed -
●: Factory setting