- 404 -
4.1.14 CT-P29x series
●: Factory setting
MSW2-2 is effective when DSW-1 is set at ON (Valid).
*1: If interface is parallel or USB, Buffer size is fixed at 4k bytes regardless of this setting.
*2: Depending on DSW-6 setting
*3: Depending on DSW-6 setting
No. Setting OFF ON
MSW1-1 Power ON Info ● Valid Not send
MSW1-2 Buffer Size *1 ● 4K bytes 45 bytes
MSW1-3 Busy Condition ● Full/Err Full
MSW1-4 Receive Error ● Print “?” No Print
MSW1-5 CR mode ● Ignored LF
MSW1-6 Reserved ● Fixed -
MSW1-7 DSR Signal ● Invalid Valid
MSW1-8 Reserved ● Fixed -
MSW2-1 Reserved - ● Fixed
MSW2-2 Auto Cutter Invalid ● Valid
MSW2-3 Spool Print ● Invalid Valid
MSW2-4 Full Col Print ● LineFeed WaitData
MSW2-5 Resume aft PE ● Print next line Print top line
MSW2-6 Reserved *3 - -
MSW2-7 Reserved ● Fixed -
MSW2-8 Reserved - ● Fixed
MSW3-1 Resum Cttr Err ● Valid Invalid
MSW3-2 Reserved ● Fixed -
MSW3-3 Parallel 31 Pin ● Valid Invalid
MSW3-4 Reserved ● - -
MSW3-5 Column Number *2 ● 48(CT-P292,3)
● 34(CT-P290,1)
32
32
MSW3-6 Reserved ● Fixed -
MSW3-7 CBM1000 Mode ● Invalid Valid
MSW3-8 Resum Open Err ● Close Command
MSW4-1 Reserved - ● Fixed
MSW4-2 Reserved - ● Fixed
MSW4-3 FEED&CUT at TOF Invalid ● Valid
MSW4-4 Reserved ● Fixed -
MSW4-5 Reserved ● Fixed -
MSW4-6 Reserved ● Fixed -
MSW4-7 Reserved ● Fixed -
MSW4-8 Partial only ● Invalid Valid
MSW5-1 Reserved ● Fixed -
MSW5-2 Reserved ● Fixed -
MSW5-3 Reserved ● Fixed -
MSW5-4 Reserved ● Fixed -
MSW5-5 Reserved ● Fixed -
MSW5-6
Speed/Quality Speed
● Quality
MSW5-7 Reserved ● Fixed -
MSW5-8 Reserved ● Fixed -
To Next Page
Loading...
