- 406 -
4.2 Details of Memory Switches
This section describes the function of memory switch.
Some MSW may not be set or some values may not be selected depending on the model used. For the
MSW and value that can be set or selected with the model you are using, refer to the operation manual
or the like.
4.2.1 MSW1
●MSW1-1: Setting the power ON notify
[Outline] At power ON, to notify the host of the printer power ON, printer can send to host 3 byte power ON notify
statusdata (3BH31H 00H).
Set toenable/disable for sending thepower ONnotify status data.
OFF(0) ON(1)
Power ONInfo Valid Notsend
ON(1) OPERATION:
Functionto notifypower ONis disabled, sending nostatus tohost.
OFF (0) OPERATION:
Functionto notifypower ONis enabled, sending status tohost.
●MSW1-2: Input buffer
[Outline] Select theinputbuffer (receive buffer) size.
OFF(0) ON(1)
BufferSize 4Kbytes 45bytes
ON(1) OPERATION: Input buffer size is set to 45bytes.
From when free area decreases to 16 bytes until it increases to 26 bytes, receive buffer is full with printer
BUSY status.
OFF (0) OPERATION:Input buffer size is set to 4Kbytes.
From when free area decreases to 128 bytes until itincreases to 256bytes, receive buffer is full with printer
BUSY status.
To Next Page
Loading...
