- 125 -
ESC u n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29xseries CT-S310II
[Function] Sendingtheperipheral device status
[Code] <1B>H<75>H<n>
[Outline] [The specification which is commontothemodel]
•Send the currentdrawer kick connector pin#3status.
•n hasthe type shown in thetable below:
n Connector Pin
0 Drawerkickconnector pin#3
[Caution] [The specification which is commontothemodel]
•Status tobesent uses 1byte that hasthevalue listedin thetable below.
•DTR/DSRcontrolsends1byteonlyaftercheckingthat host isreadytoreceive (DSRsignal:space status).For
XON/XOFFcontrol,1 byte is sent without checking DSRsignal status.
•ForDTR/DSR,if hostisnotready toreceive (DSRsignal:mark status),itwaits for ready conditiontoreceive.
•Paper-end status causes BUSYstatus,thusthis command maybe inthereceive-not-ready status.
•Thiscommandis validonlywhen MSW3-7isset to ON.
Value
Bit Function
0 1
0 Pin#3 level ‘L’ ‘H’
1 Undefined
- -
2 Undefined
- -
3 Undefined
- -
4 Unused 0:Fixed -
5 Undefined - -
6 Undefined - -
7 Undefined - -
[Sample Program]
OPEN"COM1:N81NN"AS#1 -> OPEN statement depends on types of BASIC.
PRINT#1,CHR$(&H1B);"u";CHR$(0)
A$= INPUT$(1, #1)
CLOSE #1
To Next Page
Loading...
