- 335 -
ESC S
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Selecting STANDARD MODE
[Code] <1B>H<53>H
[Outline] [The specification which is commontothemodel]
•Switchesfrom PAGE MODE to STANDARD MODE.
[Caution] [The specification which is commontothemodel]
•Thiscommandis onlyeffectiveif it isentered whenin PAGE MODE.
•Anydata mappedinPAGE MODE is erased.
•After this command isexecuted, the beginning of thelineis taken asthe next print start position.
•The print area definedby ESCWisinitialized.
•The commands listed below,whichhave separate settings for STANDARD MODE andPAGEMODE, are
changedtothe settingsforSTANDARD MODE use.
(1) Spacing setting: ESC SP,FSS
(2) Linefeed width setting: ESC 2, ESC3
•The following commandsare valid onlyin setting inSTANDARD MODE.
(1) ESCW Setsthe space amount for settingprint area inPAGEMODE.
(2) ESCT Selects theprinting direction of character inPAGE MODE.
(3) GS $ Sets theabsolutepositionofcharacter verticaldirectioninPAGE MODE.
•STANDARDMODEisselected whentheprinter isturned onor reset, orwhen ESC@ is executed.
[See Also] FF, ESCFF, ESC L
To Next Page
Loading...
