- 127 -
GS a n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 PMUseries
Supportmodel
CT-S281
CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310II
[Function] Enabling/disabling ASB(Automatic Status Back)
[Code] <1D>H<61>H<n>
[Range] 0≤n≤255
[Outline] [The specification which is commontothemodel]
•Thiscommandselectsthestatus item tobe addressed byASB(Automatic Status Back.)
Bit Status ItemAddressedbyASB Hex. Decimal
Statusofpin 3of drawerkick-out connector= Disabled
00H 0
0
Statusofpin 3of drawerkick-out connector= Enabled
01H 1
Online/offlinestatus= Disabled
00H 0
1
Online/offlinestatus= Enabled
02H 2
Errorstatus =Disabled
00H 0
2
Errorstatus =Enabled
04H 4
Continuous Paper Sensor =Disabled
00H 0
3
Continuous Paper Sensor =Enabled
08H 8
4
Undefined
- -
5
Undefined
- -
6
Undefined
- -
7
Undefined
- -
[Caution] [The specification which is commontothemodel]
•Ifanystatusitemisenabled,thestatusissenttothehostwhenthiscommandisexecuted.Afterthattimeon,
thestatusissenteachtimeanenabledstatusitemchanges.Becauseeachstatusitemrepresentsthecurrent
condition, status items disabled for ASB mayalso havechanged.
•The ASB function is disabled if allstatusitems are disabled.
• Ifthe ASB function is enabled by default, the host receives the status the first time the printer gets ready for
communicationafter itisturned on.
•The printer sends 4bytes ofstatus showninthetablesbelow,without checking whetherthe host isreadyto
receive or busy.The4 bytes of status isa continuousstring except forXOFFcode.
• Because this command is executed when data is mapped in the receive buffer, there may be a delay
between commandreceivingandstatus sending depending on theconditionof thereceive buffer.
•Even if theprinterisexcludedfrom the selection ofperipheral equipment ESC =,the 4bytes ofstatus is sent
to the host wheneverstatus changes.
• When DLE EOT, GS I, or GS r is used, the host must discriminate between the status specified by these
commands andthestatusduetoASB.
To Next Page
Loading...
