Citizen CT-S280 - Page 198

- 197 -
CT-S281
• Setting MSW 1 (a=1)
n b (Set Value) Function
48 (Default) Reports the power on.
1
49 Does not report power on.
48 (Default) Sets input buffer capacity to 4K bytes.
2
49 Sets input buffer capacity to 45 bytes.
48 (Default) Sets input buffer full and offline to be Busy.
3
49 Sets to be busy with input buffer full.
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
4
49 At the occurrence of receiving error, ignores the data.
48 (Default) Disables CR (0DH).
5
49 Enables CR (0DH).
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
8 48 (Default) Reserved
• Setting MSW 2 (a=2)
n b (Set Value) Function
1 49(Default) Reserve
48 Disables auto cutter.
2
49 (Default) Enables auto cutter.
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After cover close and PE recovery, prints as it is.
5
49
After cover close and PE recovery, prints from the beginning
using PAGE MODE, barcode, image, double-height printing,
etc. as a unit.
6 49 (Default) Reserved
7 48 (Default) Reserved
48 Enables PNE.
8
49 (Default) Disables PNE.
• Setting MSW 3 (a=3)
n b (Set Value) Function
48 (Default) After clearing cutter error, can be restored by Feed SW.
1
49 After clearing cutter error, cannot be restored by Feed SW.
2 48 (Default) Reserved
3 49 (Default) Reserved
4 48 (Default) Reserved
5 48 (Default) Reserved
6 48 (Default) Reserved
48 Sets EPSON compatible mode.7
49 (Default) Sets CBM270-compatible mode.
48 (Default)
Sets cover open error during printing to be auto recovery
error.
8
49
Sets cover open error during printing to be recoverable
error.