- 208 -
CT-S4000
• Setting MSW 4 (a=4)
n b (Set Value) Function
48 (Default)
At the selection of Black mark paper/ label paper, enables
auto end-measurement.
1
49
At the selection of Black mark paper/ label paper, disables
auto end-measurement.
48 (Default) Setting the first position at power ON disabled.
2
49 Setting the first position at power ON enabled.
48 Paper heading cut disabled.
3
49 (Default) Paper heading cut enabled.
48 (Default)
Uses thermal roll paper.
4
49
Uses Black mark paper/ label paper.
48 (Default) Detects paper position and black mark.
5
49 Detects paper position and inter-label distance.
6 48 (Default)
Reserved
7 48 (Default)
Reserved
48 Forcible partial cut disabled.
8
49 (Default)
Forcible partial cut enabled (full but by command: enabled).
* Default setting of MSW4-4 depends on the model. Thermal paper is the
default of the standard model.
* MSW 4-5 is valid only for black mark/label model. If MSW4-4 is set for
thermal paper, it is invalid
* MSW4-8 is invalid when black mark/label is selected. Cut type for black
mark/label paper is only full cut.
• Setting MSW 5 (a=5)
n b (Set Value) Function
48 (Default) Buzzer sound enabled.
1
49 Buzzer sound disabled.
48 (Default) Basic calculation pitch (180 dpi / 360 dpi).
2
49 Basic calculation pitch (203 dpi / 406 dpi).
48 USB mode virtual serial.
3
49 (Default) USB mode printer class.
4 48 (Default) Reserved
48 (Default) Reports the power off.
5
49 Does not report power off.
6 48 (Default) Reserved
7 48 (Default) Reserved
8 48 (Default) Reserved
To Next Page
Loading...
