- 211 -
BD2-2220
• Setting MSW 1 (a=1)
n b (Set Value) Function
48 (Default) Reports the power on.
1
49 Does not report power on.
48 (Default) Sets input buffer capacity to 4K bytes.
2
49 Sets input buffer capacity to 45 bytes. (Note)
48 (Default) Sets input buffer full and offline to be Busy.
3
49 Sets to be busy with input buffer full.
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.4
49 At the occurrence of receiving error, ignores the data.
48 (Default) Disables CR (0DH).
5
49 Enables CR (0DH).
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
8 48 (Default) Reserved
• Setting MSW 2 (a=2)
n b (Set Value) Function
1 49 (Default) Reserved
2 48 (Default) Reserved
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After head-down* and PE recovery, prints as it is.
5
49
After head-down* and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6 49 (Default) Reserved
7 48 (Default) Reserved
8 48 (Default) Reserved
• Setting MSW 3 (a=3)
n b (Set Value) Function
48 (Default) After clearing cutter error, can be restored by Feed SW.
1
49 After clearing cutter error, cannot be restored by Feed SW.
2 48 (Default) Reserved
48 (Default) Resets with parallel pin 31.
3
49 Does not reset with parallel pin 31.
4 48 (Default) Reserved
5 48 (Default) Reserved
6 48 (Default) Reserved
7 48 (Default) Reserved
48 (Default)
Sets head-up* error during printing to be auto recovery
error.8
49 Sets head-up* error during printing to be recoverable error.
* Name depends on a mechanism to use.
LT2X20 series: Head-down/Head-up
LT2X21 series: platen-close/platen-open
To Next Page
Loading...
