- 235 -
CT-S2000
• a=116: Sets the paper specified by (nL+nH×256).
(nL+nH×256) Paper
1(Default) Specified single color paper.
257 Recommended 2-color paper5
• a=201: Outputs ACK to the position specified by (nL+nH×256).
(nL+nH×256) ACK Output Position
1(Default) ACK-in-Busy
2 ACK-while-Busy
3 ACK-after-Busy
• a=202: Controls input buffer full Busy with the value selected by
(nL+nH×256) and controls Busy with output/cancel timing
(remaining capacity).
When Input Buffer
Capacity “Small” is Set
When Input Buffer
Capacity 4K Bytes
(Large) is Set
(nL+nH×256)
Output Cancel Output Cancel
1 16 26 128 256
2 16 40 128 512
3 30 50 72 256
4 30 60 72 512
• XON/XOFF is also output by the establishment of conditions.
• Ignores the data received when input buffer idle capacity is 0.
• a=212: Selects DMA (Direct Memory Access) control of serial
communication specified by (nL+nH×256).
(nL+nH×256) DMA control
1 Invalid
2(Default) Valid
• a=213: Selects the flow control specified by (nL+nH×256) when virtual
COM is set.
(nL+nH×256) Flow control
1(Default) PC setting
2 DTR/DSR
3 XON/XOFF
• a=214: Select the enable/disable of Kanji specified by (nL+nH×256)
(nL+nH×256) Kanji
1 Invalid(OFF)
2(Default) Valid(ON)
• a=220: Sets the maximum width of black mark by the amount selected by
(nL+nH×256).
1≤(nL+nH×256)≤32767
Unit: 1 dot
Initial value: 40 dots
To Next Page
Loading...
