ComNav Commander P2 - Battery; Fishzag Time; Watch Alarm

ComNav Commander P2 & P2VS Installation & Operation Basic Operations
Document PN 29010074 V4.1 - 120 -
Watch Alarm
The P Series autopilot has a built-in Watch Alarm. This menu line allows you to turn on the
Watch Alarm, and set how much time is allowed to elapse before the alarm goes off. This
menu line is “password protected” to prevent unauthorized personnel from changing the
settings of this alarm. See the Advanced Operations chapter of this manual for complete
details on the Watch Alarm & password.
Fishzag Time
This sets the time interval between course changes while executing the special Fishzag turn.
The units are seconds, and each click of the
C
C
O
O
U
U
R
R
S
S
E
E
C
C
H
H
A
A
N
N
G
G
E
E knob will change the interval by
thirty seconds. See Fishzag in the Advanced Operations chapter.
Battery
This is a read-only display; it can not be changed.
The number shown is the battery voltage as measured at the Signal Processor Unit, after the
logic fuse F1 – so it will be a little less than the voltage at the SPU’s J1 – BATTERY INPUT
connector, and (depending on how you have wired the SPU) somewhat less than the voltage
at your boat’s battery terminals.
• If the measured voltage is 10 Volts or less, a BATTERY LOW alarm will occur (see
page 195).