ComNav Commander P2 - Control Head Mounting & Cover Kits; Figure 23 - Control Head Mounts & Cover

ComNav Commander P2 & P2VS Installation & Operation System Overview
Document PN 29010074 V4.1 - 40 -
Control Head Mounting & Cover Kits
PN 30110003 – Flush Mount Bezel, P2
PN 30110004 – Surface Mount Bezel, P2
PN 30110006 – Bracket
PN 30110019 – Cover
PN 30110022 – Flush Mount Bezel, P2VS
PN 30110023 – Surface Mount Bezel, P2VS
The Control Head (when shipped as part of a complete Commander P2 system) is a “core”
module, and comes with accessory kits for three methods of mounting it: a snap-on bezel for
flush mounting, a snap-on bezel for surface mounting, and a two-piece bracket for bracket
mounting. All required hardware is included with each kit (except for two fasteners needed to
fasten the bracket to the desired mounting surface).
A cover for the Head is also supplied (for use with the surface & bracket mounts); it slips on
easily, to provide protection against the elements, UV rays, and so on.
The bezel/bracket kits, the cover, and the Head ↔ SPU cable & connector, are also included
with the Second Station Kits.
Figure 23 – Control Head Mounts & Cover