ComNav Commander P2 - Figure 51 - Wiring Connections for Shunt Field Reversing Motors; Figure 52 - Wiring Connections for Standard Four-Way Solenoid Valves; Standard Four-Way Solenoid-Activated Hydraulic Valves

ComNav Commander P2 & P2VS Installation & Operation Installation
Document PN 29010074 V4.1 - 72 -
Figure 51 – Wiring Connections for Shunt Field Reversing Motors
Standard Four-Way Solenoid-Activated Hydraulic Valves
Connection to 12 VDC or 24 VDC solenoids should be made as per the following diagram.
In this configuration, the autopilot supplies the positive voltage ( SW’D B+ ) whenever the
autopilot is in POWER STEER , AUTO , or NAV modes. SW’D B+ is turned off in STANDBY
mode, thus providing an extra measure of safety.
Figure 52 – Wiring Connections for Standard Four-Way Solenoid Valves