ComNav Commander P2 - Linear Rudder Follower Unit; Twin-Fin Wind Transducer; Auxiliary Controllers; Figure 17 - Linear RFU

ComNav Commander P2 & P2VS Installation & Operation System Overview
Document PN 29010074 V4.1 - 36 -
Linear Rudder Follower Unit
PN 20330002
Installations on boats with outboard motors may use a ComNav Linear RFU. It is
mechanically coupled to the motor’s steering cylinder.
Figure 17 – Linear RFU
Twin-Fin Wind Transducer
PN 20640020
For use with sailboats, ComNav’s Twin-Fin Wind Transducer provides accurate wind speed
and wind angle data to the Commander P2 SPU. This allows the boat to steer to a specific
angle relative to the wind. An easy, snap-in attachment for mast mounting is included.
Figure 18 – Twin-Fin Wind Transducer
The Twin-Fin Transducer can be “shared”: it can be wired simultaneously to a
Commander P2 SPU and either a ComNav NX2 Wind Data Instrument (PN 20620050),
or a full Nexus Classic or NX2 Network System (various PNs); see page 68 for details.
Auxiliary Controllers
Up to two Auxiliary Controllers may be added to the standard Commander P2 system. These
may be any combination of Commander Control Heads (colour and/or monochrome),
CR-203 Handheld Remotes, and TS-203 Fixed Remotes.