ComNav Commander P2 - Appendix 3: Error Messages

ComNav Commander P2 & P2VS Installation & Operation Appendices
Document PN 29010074 V4.1 - 193 -
ID Field 1 Field 2 Description Notes
SR NAV1[,T],
NAV2[,T], VANE
Wind Source if `T´ is omitted, wind is
assumed to be Apparent
WIND TP – Wind-tack points:
x.y (degrees) – Tack
x.y (degrees) – Close Reach
x.y (degrees) – Beam Reach
x.y (degrees) – Broad Reach
x.y (degrees) – Gybe Hold
WORK TRM OFF, AUTO Auto-trim configuration
for WORK mode
TPT xx.y (no units) WORK mode speed trip
point
SCL – WORK mode rudder
scale
END – – End of the configuration.
When this ID is received
during an “Rx” transfer, the
Vessel Configuration will
return to Idle
START – – Start of the configuration.
When this ID is received
while in the Dockside Setup
menu, if Configuration is not
“Rx”, a “Tx” transfer to the
NAV1 port will start
automatically.
This does not ever initiate an
“Rx” transfer, however.
Table 13 – Configuration Save & Restore Sentences