ComNav Commander P2 - Power Steer, Auto, and Nav Menu Parameters

ComNav Commander P2 & P2VS Installation & Operation Settings & Notes
Document PN 29010074 V4.1 - 220 -
Parameter Range Default Value User Settings 1 User Settings 2
Power Steer Menu
P.Str Rudder Limits
Off, or 5° up to physical limits
from Dockside Setup
Off
Auto/Nav
Rudder Limits
Off, or 5° up to physical limits
from Dockside Setup
Off
RAI Offset 0° – 15° 0
Auto Menu
Rudder Gain 1 – 10 Lo: 8, Hi: 5 Lo: Hi: Lo: Hi:
Counter Rudder 0 – 10 Lo: 3, Hi: 3 Lo: Hi: Lo: Hi:
Seastate Auto, 1 – 10 Lo: A, Hi: A Lo: Hi: Lo: Hi:
Turn Rate
0.1 – 10°/sec, or 0.1 – 12°/sec
(if Vessel type is Sail)
Lo: 8, Hi: 5 Lo: Hi: Lo: Hi:
Parameter Set Lo, Hi, Auto Auto
Speed Trip Pt. 2 – 20 10
Speed Source NAV1, NAV2 NAV1
ALC On, Off Off
Thruster Assist
(only if Thrust Type
is not None)
Off, or
0.5 – 7 (in 0.5 steps)
Off
Thruster Gain
(only if Thrust Type
is not None)
Low, Med, High Low
Nav Menu
Nav Source NAV1, NAV2 NAV1
XTE Limit 0.01 – 3.0 (in 0.01 steps) 0.25
Waypoint Arrival Silent, Manual, Auto Auto
Correction XTE, CTS, Both Both
XTE Sense Norm, Rev Norm
Max Correction 30° – 90° 60°