D-Link DWC-1000 User Manual 101
Section 4 - Advanced WLAN Conguration
Manual Change Channel and Power of Managed AP
Path: Wireless > Access Point > Managed APs List > Managed APs
From the Managed AP page, you can also manually change the RF channel and power for each radio on an AP.
The manual power and channel changes override the settings congured in the AP prole (including automatic
channel selection) and take eect immediately. The manual channel and power assignments are not retained
when the AP is reset or if the prole is reapplied to the AP, such as when the AP disassociates and re-associates
with the controller.
1. Click Wireless > Access Point > Managed APs List > Managed APs tab.
3. Select the channel as your desired. The available channels depend on the radio mode and country in
which the APs operate. The manual channel change overrides the channel congured in the AP prole
and is not retained when the AP reboots or when the AP prole is reapplied.
4. Change the power as your desired. You can set a new power level for the AP. The manual power change
overrides the power setting congured in the AP prole and is not retained when the AP reboots or
when the AP prole is reapplied.
5. Click Save.
2. Right-click on one of the entries, and select Channel and Power.