D-Link DWC-1000 User Manual 350
Section 9 - Maintenance
Congure SNMP Access Control List
1. Go to Maintenance > Management > SNMP > Access Control List tab.
2. Click Add Access Control.
3. Fill-in the elds (refer to the table below).
4. Click Save.
Field Description
IP Address The IP Address of the SNMP trap agent.
Subnet Mask The network mask used to determine the list of allowed SNMP managers.
Community The community string to which the agent belongs.
Access Type Access will be either read only (ROcommunity) or read-write (RWcommunity).
To Next Page
Loading...
