EasyManuals Logo

D-Link DWC-1000 User Manual

D-Link DWC-1000
390 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
D-Link DWC-1000 User Manual 19
Section 2 - Installation
Unpacking
Follow these steps to unpack the wireless controller and prepare it for operation:
1. Open the shipping container and carefully remove the contents.
2. Return all packing materials to the shipping container and save it.
3. Conrm that all items listed under section ”Package Contents” on page 17 are included in the
shipment. Check each item for damage. If any item is damaged or missing, notify your authorized D-Link
representative.
Selecting a Location
Selecting the proper location for the wireless controller is essential for its successful operation. To ensure optimum
performance, D-Link recommends that you perform a site survey. A site survey should enable you to:
Identify how Wi-Fi coverage should be provided.
Determine access point placement locations, and identify areas with weak signal or dead spots that
require additional access points.
Determine areas of heavier usage that might require dense access point coverage.
Determine the indoor propagation of RF signals.
Identify potential RF obstructions and interference sources.
Run a spectrum analysis of channels of the site to ascertain current RF behavior, and detect both 802.11
and non-802.11 noise.
Run an access point-to-client connectivity test to determine maximum throughput achievable on the
client.
After the site survey is complete, use the collected data to set up an RF plan using the Basic Planning Worksheet
in Appendix A. After you complete the Basic Planning Worksheet, select a location for the wireless controller. The
ideal location should:
Be at and clean, with no dust, water, moisture, or exposure to direct sunlight or vibrations.
Be fairly cool and dry, and does not exceed 104
0
F (40
0
C).
Not be prone to variations in temperature and humidity, or close to strong magnetic elds or a device
that generates electric noise.
Not place the wireless controller next to, on top o, or below any device that generates heat or will block
the free ow of air through the wireless controllers ventilation slots. Leave at least 3 feet (91.4 cm) clear
on both sides and rear of the controller.
Allow you to reach the wireless controller and all cables attached to it.
Have a working AC power outlet that is not controlled by a wall switch that can accidentally remove
power to the outlet.
Installation
A DWC-1000 wireless controller system consists of one or more wireless controllers and a collection of DWL-
2600AP, DWL-3600AP, DWL-3610AP, DWL-6600AP, DWL-6700AP, DWL-8600AP, DWL-6610AP, DWL-8710AP, and/
or DWL-8610AP access points that are organized into groups based on location or network access. This section
describes how to unpack and install the wireless controller system.

Table of Contents

Other manuals for D-Link DWC-1000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DWC-1000 and is the answer not in the manual?

D-Link DWC-1000 Specifications

General IconGeneral
Ethernet LANYes
Wi-Fi standards802.11a, 802.11b, 802.11g
Networking standardsIEEE 802.1Q, IEEE 802.1x, IEEE 802.3, IEEE 802.3ad, IEEE 802.3u
Ethernet LAN data rates10, 100, 1000 Mbit/s
Number of managed Wi-Fi Access Points (max)6
Security algorithms3DES, DES, WEP, WPA, WPA2
USB 2.0 ports quantity2
Ethernet LAN (RJ-45) ports4
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity0
CertificationFCC B, CE B, VCCI, C-tick, IC, cUL, LVD (EN60950-1)
Built-in displayNo
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)5 - 95 %
Power requirementsDC 12V/2.5A
Power consumption (typical)19.3 W
Pallet width1200 mm
Pallet length1100 mm
Pallet height (air)1419 mm
Pallet height (sea)1847 mm
Pallet gross weight (air)415236 g
Pallet gross weight (sea)545648 g
Quantity per pallet (air)144 pc(s)
Quantity per pallet (sea)192 pc(s)
Shipping (inner) case width296 mm
Shipping (inner) case height428 mm
Shipping (inner) case length354 mm
Shipping (inner) case weight10826 g
Shipping (inner) case net weight10016 g
Number of cartons per pallet (air)36 pc(s)
Number of cartons per pallet (sea)48 pc(s)
Quantity per shipping (inner) case4 pc(s)
Weight and Dimensions IconWeight and Dimensions
Package depth396 mm
Package width273 mm
Package height80 mm
Package weight2504 g
Dimensions (WxDxH)280 x 180 x 44 mm

Related product manuals