D-Link DWC-1000 User Manual 345
Section 9 - Maintenance
Management
Remote Management
Path: Maintenance > Management > Remote Management
Note: This feature is only available with the DCS-1000-VPN license activation.
The Remote Access page allows you to enable remote management from outside your local network to congure
your wireless controller. Select HTTP and/or HTTPS.
Note: When remote management is enabled, the controller is accessible to anyone who knows its IP address. It is
HIGHLY RECOMMENDED that you change the default administrator and guest passwords before continuing.
1. Go to Maintenance > Management > Remote Management.
2. Set HTTP and/or HTTPS to On. If you select HTTPS, you may enter a port (4443 is the default setting).
3. To understand each eld, refer to the table given on the next page.
To Next Page
Loading...
