D-Link DWC-1000

D-Link DWC-1000 User Manual 48
Section 3 - Basic Conguration
Step #8: Use SSID with RADIUS Sever as Authenticator
To use SSID with RADIUS authentication, perform the following procedure.
1. Go to Security > Authentication > External Auth Server > RADIUS Server page.
Field Description
Server Checking Click to test the connection between the controller and your RADIUS server.
Authentication Server
IP Address
IP address of your RADIUS authentication server.
Authentication Port RADIUS authentication port number to send RADIUS messages.
Secret
Enter the secret key that allows the device to log into the congured RADIUS server. It must
match the secret on RADIUS server.
Timeout Set the timeout in seconds. The controller should wait for a response from the RADIUS server.
Retries The number of tries the controller will make to the RADIUS server before giving up.
2. Complete the elds given below and click Save. Your access point will be congured to use RADIUS
authentication server.
3. Click Server Checking to test the connection between the DWC-1000 and your RADIUS server.