D-Link DWC-1000

D-Link DWC-1000 User Manual 165
Section 5 - Advanced Network Conguration
Field Description
Option Mode Select Load Balancing from the drop-down menu.
Load Balance Select Spillover Mode.
DNS Lookup Mode
• Option DNS Servers: DNS Lookup of the DNS Servers of the primary link is used to detect
primary Option connectivity.
• DNS Servers: DNS Lookup of the custom DNS Servers can be specied to check the
connectivity of the primary link.
• Ping these IP addresses: These IP’s will be pinged at regular intervals to check the
connectivity of the primary link.
Retry Interval is
Enter the time in seconds to initiate the DNS Lookup Mode. Default is every 30 seconds. The
number tells the controller how often it should run the above congured failure detection
method.
Failover After Enter the number of failures before the controller initiates the failover process.
Load Tolerance Enter the percentage of bandwidth after which the controller switches to the secondary Option.
Max Bandwidth This sets the maximum bandwidth tolerable by the primary Option for outbound trac.
Save Click save to activate your settings.
Spillover
1. Click Network > Internet (IPv4) > Option Mode.
2. Complete the elds from the table below and click Save.